Lenovo Vibe P1
- D
- AnonD-381901
- 8n}
- 16 May 2016
Please how to find lollipop 5.1 for vibe p1 and downgrade from marshmallow.
Which steps to do that.... Because my phone stop charging ... I have to switch it of to charge it
- k
- kelly66
- vGP
- 15 May 2016
AnonD-534378, 15 May 2016How to calibrate Lenovo Vibe P1 battery without root access... moreThanks, 2fher!
I don't have a charging to 100% problem, but during every discharge cycle I see a 1% sudden battery drop at 88%, 80, 73, 58% and thereafter a 7-8% continuous drop after it goes below 30% (start may be from 27% or 25% onwards).
Will battery recalibration solve this issue? Any particular app in mind? I am not rooted so app based recalib will not work?
- D
- AnonD-534378
- wYG
- 15 May 2016
AnonD-534378, 15 May 2016I suggest find stock rom s135
1. flash stock rom s135, ... moreHow to calibrate Lenovo Vibe P1 battery without root access?
Method 1
1. Discharge your Lenovo Vibe P1 fully until it turns itself off.
2. Turn it on again and let it turn off.
3. Plug your phone into a charger and, without turning it on, let it charge until the on-screen or LED indicator says 100 percent.
4. Unplug your charger.
5. Turn your phone on. The battery indicator will likely not say 100 percent, so plug it in (leave your phone on for this) and continue charging until it says 100 percent on-screen as well.
6. Unplug your phone and restart it. If it doesn't say 100 percent plug the charger back in until it says 100 percent on screen.
7. Repeat this cycle until it says 100 percent (or as close as you think it's going to get) when you start it up without being plugged in.
8. Now, let your battery discharge all the way down to 0 percent and let your phone turn off again.
9. Fully charge the battery one more time without interruption and you should have reset the Android system's battery percentage.
Please remember that it is not recommended to perform this process all the time. Even when your battery is so dead your phone won't even turn on, your battery still has enough reserve charge to avoid system damage. Perform this process once every three months at the most. If it is required more often than that you have bigger problems at hand.
Put plainly: fully discharging a battery is bad for it. Trying to overload a battery is also bad for it. The good news is that charging batteries automatically shut off when their safe limit is reached and there's always a little in reserve even if your Lenovo Vibe P1 won't start. But again: do this only when really necessary, because it does have a negative impact on battery life.
How to calibrate Lenovo Vibe P1 battery with root access?
Even though it is not clear if clearing the batterystats.bin file has any meaningful effect on how the Android system reports remaining battery charge, there are those who swear by this method. So in the interests of fairness the process is included for you here (it is true that different manufacturers use the batterystats.bin file for different things). It's basically the same process as above but with the added step of a root-enabled app.
++++++++++++++++++++++++
Method 2
1. Discharge your Lenovo Vibe P1 fully until it turns itself off.
2. Turn it on and let it discharge and turn off again.
3. Plug your phone into a charger and, without turning it on, let it charge until the on-screen or LED indicator says 100 percent.
4. Unplug your charger.
5. Turn your phone on. The battery indicator will likely not say 100 percent, so plug it in (leave your phone on) and continue charging until it says 100 percent on the screen as well.
6. Unplug your phone and restart it. If it doesn't say 100 percent, plug the charger back in until it says 100 percent on screen.
7. You want to repeat this cycle until it says 100 percent (or as close as you think it's going to get) when you start it up without being plugged in.
8. Now, install the Battery Calibration app and, before launching it, make sure your battery is at 100 percent again, then restart.
9 Immediately launch the app and recalibrate your battery.
10. Once you've calibrated your battery, discharge it all the way down to 0 percent and let your phone turn off again.
11. Fully charge the battery one more time without interruption and you should have reset the Android system's battery percentage.
- D
- AnonD-534378
- wYG
- 15 May 2016
kelly66, 10 May 2016Wow, that's amazing! Have you disabled some of the google a... moreI suggest find stock rom s135
1. flash stock rom s135, before u do dat make sure ur battery is 100%
2. update to s137 through internet
3. After u done dont forget to use battery calibration apps for nonrooted phone to calibrate the battery.
- D
- AnonD-534378
- wYG
- 15 May 2016
pinasyo, 10 May 201617hrs sot? really? can't imagine... maybe sot+standby mode...Yes sir :)
- r
- raj
- X}t
- 15 May 2016
In MM Battery draining very fastly as compare to lollipop
- V
- Veritas
- 0nm
- 15 May 2016
After last update 16mb phone UI become smooth again 😃
- u
- ubaid
- bEP
- 15 May 2016
Vimal , 12 May 2016Fingerprint Sensor not responding/working after Marshmallow... moreafter updating to marshmallow you have to register fingerprint again.
- p
- philax
- t7X
- 15 May 2016
mike, 13 May 2016please anybody tell me that do I have to buy new sim bcoz i... moreyes you can cut to nano sim
- D
- AnonD-214053
- uvT
- 14 May 2016
Siddhesh, 11 May 2016I m totally disappointed with the lenovo service center bec... moreVery very bad Service by Lenovo they reject my 2 day old vibe p1 DOA having network issue.
- ?
- Anonymous
- rKy
- 14 May 2016
I have updated to marshmallow on 14th may, after which the phone does not show any contacts. And also the phone default memory which was set to SD card earlier is not happening. This has made me lose data. Please help
- D
- AnonD-537040
- Nug
- 14 May 2016
AnonD-537040, 14 May 2016Owners of the phone Replies pleaseMore replies please
- D
- AnonD-185895
- fm3
- 14 May 2016
Did you find a solution for the vibration??
stopped in my device too
- s
- sparkeyyy
- Hkt
- 14 May 2016
AnonD-537040, 14 May 2016Owners of the phone Replies pleaseIm using this mobile for the past one month.Im not observing any abnormal heating issues while using light apps,but while playin heavy games the phone heats a little bit.
- D
- AnonD-265243
- RIE
- 14 May 2016
I updated my P1 to MM yesterday by following xsunilx's post in this article : http://www.gsmarena.com/newscomm-18036.php
After the update, everything is fine, except for the sudden reboots that happened a couple of times. Then, I read a post in the Lenovo forum which it says that in order to prevent the sudden reboots, you need to unrestrict all apps in the background app management. It works.
Then, last night, I got a new update and its size is 16mb. After installing this update, there's no more sudden reboots. So, now I'm just observing the battery consumption to see whether it's going to be better or worse than when it was on Lollipop.
- P
- Patrick Tan
- wce
- 14 May 2016
sumit patel , 09 May 2016in my Lenovo vibe p1 fingerprint scanner is not working,it'... moreI have the same problem recently.
Is there any solution for this?
- D
- AnonD-479387
- 56h
- 14 May 2016
AnonD-537040, 14 May 2016Owners of the phone Replies pleaseNo over heating issue. It is heating when charging the phone only.
- D
- AnonD-479387
- 56h
- 14 May 2016
AnonD-467819, 12 May 2016Things I like after the Android MM Update : 1. More than 2... moreHi, your phone lagging after you updated to Marshimoro 6.0? Others users encounter this problem.
- D
- AnonD-537040
- Nuf
- 14 May 2016
AnonD-537040, 14 May 2016I want to buy this phone and I have a question. Do you noti... moreOwners of the phone Replies please
- D
- AnonD-537040
- Nuf
- 14 May 2016
I want to buy this phone and I have a question. Do you notice abnormal heating with usage ?