Oppo Reno14 pops up on GeekBench, rocking a Dimensity 8400 chipset

Thanks to various leaks, we already know a fair bit about the upcoming Oppo Reno14. If Oppo sticks to its usual release schedule of two Reno generations a year, we can probably expect the Reno14 in June.

In the meantime, it seems like there are already early units floating around. The Reno14 goes by the PKZ110 model name on GeekBench and was spotted on GeekBench with a Dimensity 8400 chipset and a Mali-G720 MC7 GPU. These are accompanied by 12GB of RAM, and the tested phone runs Android 15.

Regarding other details about the Reno14 generation (we aren't sure whether the vanilla 14 or the Pro), we believe the phone will have a periscope telephoto - a 50MP unit with a 3.5x lens. To the left of the periscope are the two other cameras – a 50MP main with OIS and an 8MP ultra-wide camera- which are all the details we have so far.

We also believe the Pro will have an aluminum frame, an IP68/IP69 "full" water resistance rating, a flat 120Hz OLED display, and potentially a special "Magic Cube" button on the phone's left side.

Source

Reader comments

  • atan

Rear camera arrangement like redmi note 14

  • Reply
  • 4 minutes ago
  • Kxf

Wrong. 1) The Sensor is mediocre small (usually around 1/2.55" to 1/4", and 2) the DR is bad, last but not least 3) GSMArena here showed quite enough - that the 8 MP Cam, whatever brand - can't hold up with the usually 1/1.95" to ...

After years of this below-average 8 MP UWA cam from Xiaomi, Oppo has probably bought up the remaining stock. It sucks into 2025, 12/13 MP is the bare minimum standard.